The method of installing the float valve of the water dispenser is actually quite simple. Generally speaking, the float valve only needs to be pressed on the bucket of pure water. The thing that can fetch water is called a hand-pressed drinking water pump. The hand-pressed drinking water pump is actually a piston-type water pump. It is composed of a casing (cylinder liner) and a press tube (piston). , the water can be installed along the water outlet valve under the joint action of the pipe and the rubber ring.
The thing that can be directly pressed on the pure water bucket to fetch water is called a hand-pressed drinking water pump. The hand-pressed drinking water pump is actually a piston-type water pump. It is composed of a casing (cylinder liner) and a press tube (piston). , the water can be installed along the water outlet valve under the joint action of the press tube and the rubber ring.Didn’t wrap raw tape on the joints during installation, is it the kind of barrel-shaped water purifier that you reinstall? It’s very simple. Note that there is a waterproof pad in the middle. and suitable float height. That’s it. From what you said, there is a float valve under the water purifier that is installed incorrectly. You can debug it and adjust the float valve downward. Don’t let the water exceed the heat exhaust port of the water dispenser’s heat tank. The water exceeds the drain When the hot port and the hot gallbladder are heated, the heat will be discharged, which will make the drinking water…that is a problem with the water purifier, and the problem lies in the float valve under the water purifier. Check to see if the float valve is installed correctly, and reinstall the float valve. If the water still leaks, call the manufacturer quickly and ask them to replace the water purifier with another one. However, the float valve on the float valve tray fluctuates up and down with the steam velocity, so the float valve will be worn and stuck. Rust, etc… The bottom is equipped with a filler support plate, and the filler is placed on the support plate in a random pile or a whole way. Install packing pressure above the packing…For regional exploration wells, wells containing hydrogen sulfide, gas wells, and wells with high gas-oil ratio, drill 100-150 meters before the target layer, or after drilling oil and gas layers that are not indicated in the design, you must Install the drill tool float valve in the drill tool assembly in a timely manner.
1. Remove the bucket 2. Unplug the power plug 3. Turn on the faucet and drain the water. Fourth, (is the key) quickly reinstall the bucket. It is normal to have air bubbles in the bucket. If there are no air bubbles, turn on the faucet and drain the water until air bubbles come out.
Post time: Dec-29-2022
